实战 LAMP 服务器配置 完整篇
安装zlib tar zxvf zlib-1.2.3.tar.gz cd zlib-1.2.3 ./configure --prefix=/usr/local/zlib2 make make install 安装libpng tar zxvf libpng-1.2.10.tar.gz cd libp
安装zlib tar zxvf zlib-1.2.3.tar.gz cd zlib-1.2.3 ./configure --prefix=/usr/local/zlib2 make make install 安装libpng tar zxvf libpng-1.2.10.tar.gz cd libp
1.调整内存 sp_configure 'show advanced options',1 GO RECONFIGURE Go sp_configure 'awe enabled', 1 GO RECONFIGURE Go sp_configure 'min server memory',1024
1. 查看数据库的版本 select @@version 2. 查看数据库所在机器操作系统参数 exec master..xp_msver 3. 查看数据库启动的参数 sp_configure 4. 查看数据库启动时间 select convert(varchar(30)
一.xp_cmdshell EXEC master..xp_cmdshell 'ipconfig' 开启xp_cmdshell: -- To allow advanced options to be changed. EXEC sp_configure 'show advanced options'
如果你想要运行多个服务器,最容易的方法是用不同的TCP/IP端口和套接字文件重新编译服务器,因此他们不是侦听同一个TCP/IP端口或套接字。 假设一个现存服务器配置为缺省端口号和套接字文件, 那么用一个这样configure命令行设置新的服务器: shell> ./configure --wi
1、新建一个Label1来储存username,这个是我这个方法成功的关键,因为我尝试用Session("username")失败。 改用control 来传递变量,成功! 2、“GridView tasks”--“configure Data Source”--一路next下去---到了“Defi
发现新立得也有下载: sudo apt-get install rdesktop或到下载rdesktop,下载后安装:$ tar -zxvf rdesktop-1.5.0.tar.gz$ cd rdesktop-1.5.0$ ./configure$ make$ make install终端输入 r
随着IT业的飞速发展,Cisco路由器被广泛应用于各行各业,本文将从基础配置入手,简单介绍一下Cisco路由器的配置方法。 一、配置以太网端口 # conf t 从终端配置路由器(Cisco的各种命令均可以简写,只要不与其他命令重复即可,如configure terminal可以写成
ip igmp join-group与ip igmp static-group的区别?To configure the router to be a statically connected member of the specified group on the interface, use th
以前没有在4506上配置过VLAN,今天就丢人了一把,偶的配置如下:interface FastEthernet2/1switchport access vlan 20duplex fullspeed 10!interface FastEthernet2/2description Connect n